RC Remote Start Stop (Trigger) for RED

Description

RC Remote Start Stop (Trigger) for RED

The days of wasted media is over. Start and stop your RED whenever you please. Capturing aerial video using your RED got whole lot easier. Introducing the RC (Radio Control) Remote Start Stop for RED Cameras. Plug-N-Play operation with any RC Receiver that outputs PWM signal. Assign a 3 or 2 position switch to a free channel, plug in the 3 pin servo connector to the free channel of the receiver, plug in the sync cable from the trigger device to the RED camera and you are all set.

Specifications:

Operating Voltage: 5V
Current Consumption: 38mA
RC Connector: 3 Pin JR Connector (20CM)
Sync Connector: LEMO 00 4 Pin (50CM)
Weight: 1.3oz (35g)

The trigger works with default RED GPIO settings. If you changed GPIO settings please change GPIO settings to the following:

• Open RED menu in top right of LCD
• Select Settings
• Select Setup
• Select GPIO/Sync
• Select tab for Brain GPIO
• Drop down Camera Input and select General Purpose Input
• Drop down Brain GPI in High and select Record: Start
• Drop down Brain GPI in Low and select Record: Stop
• Exit the RED menu