Movi Joystick Setup Instructions

Movi Joystick installation and configuration

The steps below should be performed when the Movi is switched off.

Installing the Joystick SBUS Connector

Remove the Panel covering the SBUS port — Remove the Panel covering the SBUS port by removing the 2 x 1.5mm socket head screws

Plug in the Joystick SBUS Connector. Route the joystick wire along with existing wires.

Install the cover

Save the current profile before continuing

Using the Freefly Movi App

Using the Freefly Configurator to setup the inputs for the Joystick

General Config

Remote Controller Config

Remote Operator Config

These changes are not required but for optimum response and performance you can use these settings.