Alexmos Tiny Pro Dual IMU Setup Instructions

Alexmos Tiny Pro Dual IMU Setup Instructions

Setting up camera and frame IMU

Alexmos Tiny Pro Conntroller comes with 2 IMUs. One that’s built-in to the controller itself and an external IMU which is included in the package. By default both IMUs  are configured as Camera IMUs.

Here’s how to setup the IMUs in the following configuration

  1. Built-in IMU as the frame IMU
  2. External IMU as the camera IMU

Step 1

Remove power before continuing – Battery or USB

Alexmos Tiny Pro Dual IMU Setup Instructions

Use a sharp knife, example an Xacto Knife and locate the bridge labeled ADDR. You will notice there’s a hairline connection bridging two pads. Carefully cut the bridge using the knife.

This will make

  • External IMU – Frame IMU
  • Built-in IMU – Camera IMU
Alexmos Tiny Pro Dual IMU Setup Instructions

Step 2

Connect the controller to the GUI, under Advanced tab check  Swap main and frame sensors

Now the external IMU will function as the Camera IMU and the built-in IMU as the Frame IMU