Description
DJI NAZA-M MULTIROTOR AUTOPILOT SYSTEM FOR HOBBY
ALL-IN-ONE DESIGN
NAZA-M simplifies installation and saves space and weight. With the innovative All-in-One design, NAZA contains inner damping, controllers, 3-axis gyroscope, 3-axis gyroscope and barometer in its light and small Main Controller. NAZA can measure flying altitude, maintain and therefore can be used for autopilot/automatic driving.
ADVANCED ATTITUDE STABILIZE ALGORITHM
Advanced mix guidance algorithm and control algorithm, inherits outstanding flight stability of DJI products, provides excellent maneuverability, gives hobbyists wonderful flight experience.
MULTIPLE FLIGHT CONTROL MODE/INTELLIGENT SWITCHING
Naza-M offers three types of control modes : GPS Atti. Mode(with GPS module), Atti. Mode, Manual Mode. Customer can switch among the three modes to adjust different flight environment even in the specially weak GPS environment. Naza-M also can adjust automatically in the flight environment and intelligent switch between GPS Atti.mode and Atti. Mode to make sure the safety and security of flight.
GPS MODULE AVAILABLE/ACCURATE POSITION HOLD
Naza-M GPS will greatly enhance performance for entry AP with Position Hold, Return-To-Home and Intelligent Orientation Control. With GPS Module, the multirotors will have position and altitude lock in windy conditions. Precise hovering in less than 2.5m horizital and and 0.8m vertical.
INTELLIGENT ORIENTATION CONTROL (IOC)
Usually, the forward direction of a flying multi-rotor is the same as the nose direction. By using Intelligent Orientation Control (IOC), wherever the nose points,the forward direction has nothing to do with nose direction:
In course lock flying, the forward direction is the same as a recorded nose direction. See the following figures(Mode 2)?
In home lock flying, the forward direction is the same as the direction from home point to multi-rotor.See the following figures (Mode 2)?
FAILSAFE MODE
If your transmitter supports Fail-Safe , then you can set Fail-Safe output of receiver to input port-U .Naza controller has built-in auto level Fail-Safe function. That means when the communication between MC and transmitter is disconnected, the outputs of all command sticks from controller will go to center point . If your transmitter has only 4 channels, then MC will work in Atti. Mode by default without Fail-Safe function.
LOW VOLTAGE PROTECTION
In order to prevent your multi-rotor from crash or other harmful consequences caused by low battery voltage, we have designed two levels of low voltage protection. You can choose to not to use them, however we strongly recommend to open the protections!
Reviews
There are no reviews yet.