Little Bee 30Amp ESC 30A 4-6s – FVT

Top Performance

LittleBee is using Silabs processor and fast dedicated driver chips, providing excellent freewheeling and exceptional braking capabilities.

High Reliability

Little Bee is only using the best components available, period. And, as we build these in our own factory, our experienced staff ensures you’re getting the best of the best!

Small Size

LittleBee 30A is 35x17mm and weights 11g. Your multirotors can be smaller and lighter than ever before!

Oneshot125

Oneshot125 is a different and faster communication protocol between the flight controller and the ESC on your quadcopter. It allows the FC to send control commands to the motor quicker, therefore in theory your multirotor should perform better.

Damped mode

This feature allows your motors to respond to throttle decreases much quicker, allowing for more stable flying, and higher response to throttle decreases.

30A 2-6s

LittleBee 30A can work with up to 6s.

Easy upgrades

With the BLHELI software rapidly evolving, you can flash the lastest firmware using the 3pin connector and suitable USB adapter

• Size : 17mm x 35mm x 4mm
• Oneshot125
• Damped mode
• 30A 2S & 6S
• Opto ( No BEC )

This is what BLHeli creator Steffen has to say about it:

“This ESC has a good design with fast dedicated driver chips, which gives excellent freewheeling and exceptional braking.

Initial stress testing on 4S with a Cobra 2208/2000 with 6×4.5 prop, doing repetitive immediate accelerations from low rpm to full throttle went well.
During the initial acceleration, this setup pulls about 100A, so it’s a tough test for a small ESC (and can break other small ESCs).
Hopefully this indicates that the ESC will prove to be a reliable performer.

And so far, this is the closest performer to KISS that I have seen in this size.”