Phobotic Centerpiece New Firmware Release 1330

Posted on Leave a comment
Phobotic Centerpiece HV Brushless Gimbal Controller - 3 Axis CP HV

Phobotic Centerpiece HV Brushless Gimbal Controller - 3 Axis CP HV Phobotic Centerpiece Brushless Gimbal Controller - 3 Axis CP

 

Phobotic Centerpiece – What’s New

  • Many improvements to stabilization and Autotune
  • Gimbal Analyzer: a new feature available from the GUI that lets you run performance tests on each axis and see how well the gimbal responds on a graph.
  • Follow profiles: each axis can have up to 5 different follow configurations that can be quickly switched from the GUI.
  • Follow presets: each follow profile can be quickly set up by choosing a pre-made configuration from a list.
  • Pole position: easy fine tuning of the yaw home position (see in-app help)
  • Improved R/C position limiter:
    • Added a more intuitive GUI for setting the position limits.
    • In angle mode, the position range is mapped to the R/C travel, to avoid a dead stick range.
    • Also in angle mode, there’s now an option to set the position of the axis when the R/C stick is at zero.
    • In speed mode, the deceleration near the position limits can be made less/more abrupt.
  • Easier setup of R/C follow control
  • Fixed some saved profiles failing to load
  • Fixed R/C angle mode on an axis with follow
  • Fixed LED display of battery status
  • When autotune fails, an error message is now displayed in the GUI
  • Various improvements to the diagnostics sent in support requests
  • Lots of other small improvements & bugfixes

New Phobotic Manual

https://phobotic.com/manual/1333/

Leave a Reply