Custom order for a camera crane
Category: Projects
Alexmos 3 Axis Brushless Gimbal Controller Box – Fully Assembled
Posted on — Leave a comment
Due to large amount of requests and many having issues putting the boards together, we will be releasing the current DIY Box fully assembled and soldered.
What’s included so far:
- Alexmos 3 Axis board – not stacked
- Copper High Dissipation heatsinks mounted
- Custom 5 wire interconnect
- 12AWG or 14AWG power leads soldered and terminated with XT60 connector
- Bluetooth Module Installed
- Board flashed with the latest firmware and tested for operation
- Various ferrite rings will be included
- Box will mount using standard 2 axis board mounting pattern
Testing a few RED brushless Gimbal Setups
Posted on — Leave a comment
Adding Voltage Sensor Capability to V1 & V2 Alexmos Boards
Posted on — 2 CommentsTry this at your own risk. Advanced soldering skills and soldering iron with an extra fine tip needed.
Required parts
1 x 10K Resistor
1 x 33K Resistor
Solder one end of the 10k resistor to (-) Negative Battery Supply pad.|
Solder one end of the 33k resistor to (+) Positive battery Supply pad
Solder the 2 free end together
Solder a wire from pin number 19 of the 328 chip to the point where the 2 resistors are soldered together
Location of PIN 19
Location of PIN 19 shown with the yellow pointer
Completed view
1000mm Evolution Hex – Fitting in to a mini
Posted on — Leave a comment
